VOC Free

Flux

VOC Flux are low solid and free of alcohol.
After wave soldering  these fluxes are applied on PCBs by wave of foam, spraying, dipping or brushing. When using the foam method of application, an air knife is recommended after operation. The air knife will ensure that flux is uniformly distributed across the board and will remove the excess flux.

Refer table below for selecting grade of flux suitable for your application.

PRODUCT DESIGNATION

TECHNOLOGY

COLOUR

       SPECIFIC       GRAVITY

   NOMINAL            SOLID          CONTENT
RECOMMENDED APPLICATION

NP 900

Rosin free, Water-based, No- clean

Colourless

1.00
2.5%

Flux can be applied on printed circuit boards by dipping and brushing.